First project: skullcactus.
Aaannndd ‘we’ are off, first attempt failed due to first layer not adhering to the base plate, second attempt seems to go well, fixed it by adjusting plate temp:
Big success!!
New doorsign already edited because printing that skull takes *forever*. Not really but i'm used to gaming timing, like: immediately.
Discovered that *.webp is a far better compressable format for looped animations than *.gif or *.png are. Too bad it’s not implemented […]
Problem with AI: it’s being marketed like any new technology: first get them hooked, then sell subscriptions, it’s a lot like […]
Finally repaired sound in Linux, little bit baffled by how easy it was, a € 17,- USB Creative Soundblaster didit. Read about […]
The beauty of data visualisation
